Haunter LowPoly
Copyright Claim
Haunter LowPoly
Boost
20
41
6
Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
39 min
1 plate
Boost
20
41
6
0
61
30
Released
Description
Z height recommended not less than 40 mm
Care when removing nail holders
Profile completely in one color, supports included
Comment & Rating (6)
All
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Little fragile by the left hand, will probably print again but scale up.
(Edited)0
Reply
This is a difficult print to remove the supports, both around the fingers and in the mouth. For the supports, I highly recommend using PVA or Bambu's support material. Very nice result, though.
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld