Tree shaped decoration frames. Print 3 frames and slide them into the bases. Print them any color you want or all the same color, up to you.

If you want a nice surface then use a nice print plate and use the face of the prints that are against the print bed as the “front” facing part, that way they will be very smooth (if you use a smooth plate). I used the Sparkle Star PEY Plate from Aliexpress I love that the sparkles transfer onto the parts!

Dimensional accuracy matters. The base is a tight fit but will loosen up (mine loosened up after putting the 3 trees in and out of the bases about 5 times)

Assembly Instructions:

1. Print all 3 frames and the two bases
2. line up all 3 frames and push them into the smaller base.
   1. I tapped the frames against the table to line them up, like lining up a stack of papers, squeezing the trees tightly push them into the small base. Then push the trunk of the trees past the bottom of the 1st base so it sticks out the bottom.
3. Slightly push the trees into the larger base using your hands, then once theyre in there put the frame on a table and push the tree frames through the base till they bottom out.
   1. You can also just push the trees all the way through the base with your hands, all the way past, then just put them on the table and push only the bases down onto the table. This should help line up the trees

Tree Alignment

Sometimes the trees won't align perfectly. If you're having trouble lining them up try this method:

1. Remove the larger base.
2. With the larger base removed, spend some time to move the trees around one at a time to make sure they line up. you may need to grab one while holding the bottom base and pull the tree to the side, one way or another.
   1. Sometimes holding the small base and pushing/pulling and it wiggling it can help.
   2. You may need to hold the back one and pull the middle one till it lines up. Then hold the back 2 and pull the last one till it lines up. Moving the base around helps.
3. Once the trees are aligned hold them tightly and push them into the larger base.
   1. Putting the base on a table and pushing the trees down into the base can make it a little easier.

Please let me know if you have any requests or questions.

These models take time and work to get right, I do this for fun and not business but if you want to support me or show gratitude and buy me a coffee I'd be Extremely grateful! https://www.buymeacoffee.com/eier

Thank you