ARTHUR Ethernet RJ 45 clip secure repair fix broken / Ethernet RJ 45 clip sécurisé réparation cassé
Copyright Claim
ARTHUR Ethernet RJ 45 clip secure repair fix broken / Ethernet RJ 45 clip sécurisé réparation cassé
Boost
14
30
14
Print Profile(3)
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
V2 easy print - support included - 0.2mm layer, 2 walls, 15% infill - 1 piece
Designer
19 min
1 plate
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Boost
14
30
14
1
89
100
Released
Description
This clip to repair and secure the broken tab of an RJ45 Ethernet connector.
Best print used rjclip_arthur+v3-supported v1
Comment & Rating (14)
All
Print Profile
V2 easy print - support included - 0.2mm layer, 2 walls, 15% infill - 10 pieces
This design is flawed, especially with these supports. PLA, PETG, ABS, or TPU: doesn't matter, even in the silent/50% this is unprintable or barely printable.
Support Issue
The designer has replied
0
Reply
The 3D file is only intended for PLA Basic from BAMBU LAB
If you use another plate please adapt the temperatures to those of the manufacturer.
However you are right, there is a printing problem after printing again yesterday. I think this comes from the position of the parts which are too close because for a printing of 50 copies the problem is not present. So I'm going to update the file. thank you for your comeback.
0
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
Hi,
the idea is great, no more perfectly fine working cables for the trash.
But when I tried to remove the supports the thing broke every time. It's a bit fragile I think.
The designer has replied
1
Reply
please test the modele : easy print - support included - 0.2mm layer, 2 walls, 15% infill - 1 piece
0
Reply
Replying to @arthurFR
I will test this.
(Edited)1
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
Other Issues:lösen sich schwer von der stützstruktur...
The designer has replied
2
Reply
Indeed if you print in 0.20 less adhesion to the plate and faster printing.
0
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
2
Reply
Print Profile
V2 easy print - support included - 0.2mm layer, 2 walls, 15% infill - 1 piece
1
Reply
Print Profile
V2 easy print - support included - 0.2mm layer, 2 walls, 15% infill - 1 piece
1
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
V1 NO BEST - 0.16mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld