V2 easy print - support included - 0.2mm layer, 2 walls, 15% infill - 10 pieces
This design is flawed, especially with these supports. PLA, PETG, ABS, or TPU: doesn't matter, even in the silent/50% this is unprintable or barely printable.
The 3D file is only intended for PLA Basic from BAMBU LAB
If you use another plate please adapt the temperatures to those of the manufacturer.
However you are right, there is a printing problem after printing again yesterday. I think this comes from the position of the parts which are too close because for a printing of 50 copies the problem is not present. So I'm going to update the file. thank you for your comeback.
Hi,
the idea is great, no more perfectly fine working cables for the trash.
But when I tried to remove the supports the thing broke every time. It's a bit fragile I think.