Fidget Ring - Print-in-Place
Fidget Ring - Print-in-Place
Boost
24
49
14
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
20 min
1 plate
0.2mm layer, 3 walls, 15% infill
22 min
1 plate
Boost
24
49
14
0
83
122
Released
Description
Fidget Ring - Print-in-Place
The gear part spins around the ring. As soon as I figure out how to make my webp file actually show the video instead of a still image, I'll upload it.
The tolerance should allow for a bit of scaling either way and still work ok. I did try some white lithium grease in one of them to see if it would spin a little faster, but the results were minimal.
Printed in Blue Sapphire PLA from CC3D.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed great in silk, no changes.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Great print
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect 😊
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
not very smooth to spin and only suits large fingers unless scaled down but unable to do through the app
(Edited)0
Reply
great print!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Strength Issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld