LEGO SkeletonGuy (AMS Friendly Version)
Copyright Claim
LEGO SkeletonGuy (AMS Friendly Version)
Boost
58
83
9
Print Profile(1)
0.2mm layer, 2 walls, 7% infill
Designer
10.9 h
2 plates
Boost
58
83
9
0
141
54
Released
Description
Lego SkeletonGuy this model was designed as a companion for the various Giant Lego Skeleton Models available on other platforms. This version is scaled down to 25 percent so it prints in less than 24 hours. it was originally designed to be printed 75% larger but it takes over 60 hours to print. If your down for the challenge be my guest. I will be uploading a variant for those who would like to print this without painting or do not have access to an AMS. Credit to @Neil Lantto on Grabcad whos generic Lego man model was used as a starting point.
If requested I will add his little pumpkin bucket the original mini figure came with. Follow @TS.Makers on instagram for updates.
Comment & Rating (9)
All
Amazing! The 3 pins don't fit, but they weren't needed. If it comes apart in the future I'll put a small dab of CA on it. Thanks for making this!
The designer has replied
0
Reply
Hey thanks for printing it. I should've added it to the description. The pins are really only needed if you print at larger sizes. At smaller sizes the tension is enough to keep the waist together without them.
1
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
Be cool if it moved like a Lego figure.
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
Good quality print
(Edited)0
Reply
If you downloaded this within the first 5 minutes of me uploading it. I accidentally uploaded the wrong waist file. You can sand it to make it fit or download the updated 3mf.
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld