Filament painted print made using HueForge - Filament swaps ONLY, no mmu/ams required
2 Colour ‘Filament Painting’ model - Isometric Cube Seamless Cladding
(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Leave The Aux fan off on the bambu as it causes more harm than good on these larger prints
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm
Filaments Used:
PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6
PLA Bambu PLA Matte Ivory White Transmission Distance: 4
Swap Instructions:
Start with Charcoal
At layer #14 (0.76mm) swap to Ivory White for the rest.
Virtually and colour combination will work as long as the second colour has a Transmission Distance of 2 or higher - MIX IT UP! and show me your results
Use the exact numbers in your slicer to match up properly.
**If Scaling the model make sure not to adjust the Z-Height of the model**
ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.
Source Image by renata.s on Freepik
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.