eSUN is the brand of filament that I use the most and I have too many empty spools accumulated. I have designed these drawers so that they can be used as shelves for small items.

• Characteristics:
• They are screwed using the holes where the filament is fixed (2 screws per drawer, upper and lower. 8 screws in total).
• They have a hole to insert 17.5 x 4.5 mm magnets. These prevent the drawers from opening easily, but are not necessary.
• On the front you can insert a small sheet to indicate what is in each drawer.
• In the middle of the drawer there are guides to insert a separator, it is included in the design.

The drawers do not measure exactly 90 degrees since they must allow rotation between them, it is normal that there is a gap so that they do not collide.

NOTE: eSUN spools have 2 different sizes: 60mm and 57mm. Keep this in mind before printing!