This is a full chess set with each piece being a different character or reference to the series. The intended character-peice combination is as shown in the photos (ex. Link and Zelda are King and Queen for the “white pieces”, Ganon is the King for the “black peices”. Pieces have been sized to conform to standard chess piece sizes. The set includes several additional “alternate pieces” that can be used in place of the “standard” set. However, it should be noted that the alternate pieces were difficult to print. Every model in the main set should print.

Recommended Print Settings:
Nozzle: 0.40mm
Layer Height: .20mm or lower
Supports: Regular supports with Snug fit. Tree supports also work, but have been less reliable. Use build plate only for tree supports.
Support Threshold Angle: I printed using 20. There is a delicate balance between support threshold and print quality. These models have a lot of things that need support that are also think and delicate. Bows, arrows, fingers, etc. If you set the threshold angle too low, the print will get messed up. If you set it too high (35+) there will be so many supports that removing them from the many small delicate sections of models will be difficult to do without breaking the model.
Filament: I have only tested these models with PLA and Silk PLA. They print significantly easier with regular PLA (I used Inland). Silk PLA makes these things look awesome, but it is more brittle, and again, lots of small delicate parts.
Ironing: Several models benefit from top surface ironing. Deku Tree for example. Most do not need them.
Infill %: I recommend at least 50%. It gives the pieces a good feel and not as likely to tip over but also saves on filament.
Infill pattern: whatever you want, I think I used cubic for the most part.
Walls: 3. You can do 2 if you want, but the extra wall makes them sturdier, especially for ones with thin legs.
Print Speed: 100% or lower.

Storage: This set is not recommended as an every day chess set. It's for display and/or special occasions. If you have children in your home, you should keep these packed up. You can find “pluck and pull” foam padding online for relatively cheap. 2" is what I used. Check the photos to see what I mean.

General Printing: It may be a task, but I would suggest printing one piece at a time, especially for the larger more complicated ones.

Print Times: The larger pieces take ~2 hours to print. The pawn row takes ~1 hour per piece.