Mighty Ducks LED light box
Copyright Claim
Mighty Ducks LED light box
Boost
18
26
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.2 h
2 plates
Boost
18
26
8
0
31
6
Released
Description
Mighty Ducks LED light box! Has a 12mm hole on the side for your cord to go through. I use LED light strips around the interior of the light box, connecting to an 8-10mm solderless clamp, which then goes to a switch adapter and finally inserting to the plug cord.
Comment & Rating (8)
All
Thanks! I was going to make this the other night but now I don't have to
The designer has replied
0
Reply
no problem!
1
Reply
Replying to @Balorfan85
So I just printed this and theres a couple little pinholes that come out in the print. You can see them in the slicer too. on the left side when looking at the front. Its towards the top where the white line and green intersects. And down towards the bottom on the left side where the green and white come together next to the stick. Not sure how to fix it besides redoing the picture.
0
Reply
sounds like extrusion on your printer needs to be calibrated a bit. I set mine at 1.08, and it worked well for mine. also, the lights, I glue in and clamp them with clothespins until the glue dries. I make sure on the sharp corners I have a clothespin as close to that corner as possible.
1
Reply
How do you put your leds inside? do you route them around every corner or just through the shallow curves? And how far set back from the face? I can't get mine to stick through the sharp corners without popping back up.
The designer has replied
0
Reply
I thought this was a part of your last comment thread, so I replied there. Hope this helps!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I love it thanks for the design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld