The BitJoint is a bit-attachment that makes it possible to screw into even the most tricky corners.
The non-rotating handle makes it easy to use.
Magnets can be used inside to prevent the bit-attachment from falling out.
Max angle approx. 30 degrees
It holds surprisingly well, but watch the torque anyway. It's still plastic. :)
Printing instructions:
I have printed all parts in PETG. make sure that the Bed adhesion brim type is on "outer brim onley" with a width of 6-10 mm.
I printed the center part (the part in yellow) and the BitStick with 100% filling and 4 wall thicknesses, the rest was printed with 20% infill and 4 wall thicknesses.
All parts can be printed without support.
Materials required:
2 x M3x20mm screws
2 x M3 nuts
2 x 6x2mm magnets
Be careful when tightening the screws and nuts, or the brackets may break..
I am open to suggestions for improvement and remixes.
enjoy