M-LOK Rail Covers
- Sizes 1, 2, 3, 4 relate to number of M-LOK slots that the rail or handbrake occupy.
- Short versions can be stacked one next to another. If you prefer “standard” version, check my other remixed model.
I remixed the original version:
- reduced weight
- improved design - cut holes through the model, adjusted the angle in holes for screws
- added one extra hole in the middle of the rail cover for better look and durability
If you prefer the standard "not short" version, you can check another model - long versions have slightly extended ends, primarily to be used as a single cover.
LINK for “longer” here: WIP
Print settings:
- resolution: 0,20 mm or better
- infill 30-40%
- no supports
- 4 bottom layers
- avoid crossing walls (not required, but it could help a lot)
- arachne wall generator
- grid infill
- material: PLA/PETG/ABS (PETG or ABS recommended, but PLA is usable too)
Hardware:
You can buy original M-lok nuts and screws. However, you can also go on a cheaper way, check below:
- M4 2020 series sliding T-nut
- M4 10/12mm flat head socket countersunk bolts screw