i'm a beginner, this was my first print after the benchy and it came out all clogged up.. 😂
should have taken the v2. it took a long time to smash every support inside into pieces with a screwdriver and take it out.. now the ocarina plays well (its really loud though, for the sake of my neighbors I didn't play for a long time).
i just give one star because i used this model instead the v2 because of the better rating. maybe it can "save" someone else. otherwise great model!😊
v2, support on build plate only 0.2mm layer, 2 walls, 15% infill
I had try this print on the A1 before multiple times and it always failed, now I used the x1c and it worked flawlessly. I edited the printing profile a bit when it comes to supports and the infill is set to gyroid
v2, support on build plate only 0.2mm layer, 2 walls, 15% infill
Prints pretty well and for the most part well supported. Not sure I'm that keen on the randomised seam. And tree supports could improve the hole quality.