Traxxas Slash 2WD Stand
Copyright Claim
Traxxas Slash 2WD Stand
Boost
1
2
1
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
2.4 h
2 plates
Boost
1
2
1
0
2
5
Released
Description
All of the stands I have found are for the Traxxas Slash 4x4, so I took it upon myself to design a simple stand for my Slash to keep the wheels off the ground when in storage on the shelf.
For assembly, you need the following:
(8) M3x10-12mm screws. The "pre-drilled" holes are 12mm deep, so do not use anything longer than 12mm!
This is a new model that has not yet been fully tested, so if you have any modifications you find beneficial to the design, feel free to reach out.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
20
Filament:eSun PLA Plus Any
Notes:
The sides and braces do not needs supports however, I recommend you stand the top up on its end and print with supports.
Comment & Rating (1)
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld