You can now recycle your tree supports!

How To Print

1.find a proper place and break the tree support down

1.找个合适的位置掰断支撑

2. measure the support's inside diameter like this, and remember the results (in millimeters）

2. 测量树支撑的内径，记住结果（单位毫米）

3. measurementResult×100 and tap it into the slicer's scale tool (by percentage) to modify the size

3. 将测量结果乘以100，并输进切片器按百分比修改大小的工具里

4.Slice and print! Also notice that the trophy model need supports!

4.切片并打印！同时注意奖杯模型需要支撑！

5. Assembly! If you can't insert it , you can slightly polish it and try again

5.组装！如果插不进去可以用砂纸略微打磨

I'm asking bambulab to add some features that can scale these model on bambu handy, so it might be easier to print later

Also Happy NewYear for every one!!!

祝大家新年快乐！！！

(This model was first released in 2024.1.1)