Zephyr Edge for Transformers Legacy Windblade

Wanted to arm Windblade a little more with another melee weapon, so here's introducing the Zephyr Edge!

Sporting a standard 5mm handle, so that all bots will be able to hold it, here's Windblade all armed with one! We've given it a slightly longer handle so Windblade can using it in a dual handed manner! Also in case you would like to use it with other larger bots too.

A bunch of 3mm pegs have been designed into the hilt, so effect parts can be added to your heart's desire. With the same 3mm peg, this would allow the Zephyr Blade to be pegged into Windblade's side, much like her original sword.

As an optional method of attachment, the opposite side of the hilt comes with a 5mm peg, so this weapon can be added onto any 5mm ports on your bots. Shown here with a pair of these blades!

And if you have the earlier Cyclonus sword stand (https://www.patreon.com/posts/52373279) handy, these display nicely on them too!

Over to Windblade's alt mode, the Zephyr Edge will fit right under her wings using the previously mentioned 5mm ports.

===

This blade prints as a single piece and should be pretty straightforward. It is advised to 3d print it vertically in FDM for best detailing, or better yet, in 3d print it in resin.

So as always, happy 3d printing and have fun adding this to Windblade's and your other bots' arsenal! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog