UPDATED kitchen conversion chart
Copyright Claim
UPDATED kitchen conversion chart
Boost
463
823
169
Print Profile(5)
with holes to hang
Designer
1.8 h
1 plate
V2 updated 0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
A1 Mini, 0.2mm layer, 2 walls, 15% infill
48 min
1 plate
0.2mm nozzle, 0.1mm layer
3.9 h
1 plate
Click to see more
Boost
463
823
169
3
924
905
Released
Description
Edit - Reorientated and enlarged so now it prints loads better and all words a readable but would still benefit from a 0.2mm nozzle but no longer a big difference.
will look 100% better with a 0.2mm nozzle but i don't have one fitted at the minute so did it with a 0.4mm thats why a couple of letters don't look great.
Comment & Rating (169)
All
Great gifts. Thanks very much!
2
Reply
These looks amazing. Did you use a 0.2mm nozzle for these?
0
Reply
Print Profile
V2 updated 0.2mm layer, 2 walls, 15% infill
Smaller nozzle would help, however are you sure you have "detect thin walls" on in this profile? Also, actually disabling Arachne walls can also make it look better, as it will at least extrude the 0.4 nozzle with, and you won't end up with incomplete letters as this profile.
The top part is perfect though, only the bottom part is not suitable for 0.4mm
The designer has replied
1
Reply
I have detect thin walls on and i tried with Arachne on and off and this was the best way.
(Edited)1
Reply
Print Profile
with holes to hang
I was actually getting worried around layer level 5 since the print looks like it was failing. I waited and I should have not worried. It looks great! Thanks.
1
Reply
I noticed that 1 GALLON at the bottom has that off kilter "L" but that looks the same as the authors print as well.
(Edited)1
Reply
⭐⭐⭐⭐⭐
Bambu Lab PLA Basic Black and White. Great model! Thank you!
1
Reply
Print Profile
V2 updated 0.2mm layer, 2 walls, 15% infill
Turned out well.
1
Reply
Print Profile
V2 updated 0.2mm layer, 2 walls, 15% infill
very nice! I printed with a 0.4 nozzle, so obviously I lost some clarity (but that’s on me). I put it up on my kitchen cabinet for reference!
(Edited)
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer
very nice print 👌
1
Reply
Print Profile
V2 updated 0.2mm layer, 2 walls, 15% infill
Good quality. I stick a magnet to it and attached to the fridge
(Edited)
1
Reply
Print Profile
V2 updated 0.2mm layer, 2 walls, 15% infill
Printed beautifully even with a 0.4 Nozzle. Thank you.
1
Reply
Print Profile
with holes to hang
my wife loves it!
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld