Spiral Ball Drop Fidget
Copyright Claim
Spiral Ball Drop Fidget
Boost
73
109
38
GIF
GIF
Print Profile(2)
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
1 ball fidget 0.2mm layer, 2 walls, 15% infill
Designer
54 min
1 plate
Boost
73
109
38
0
262
272
Released
Description
Please give me a like if you enjoyed this, it helps a lot.
Voronoi Ball drop fidget for you and your family and friends.
Print in place, no supports. Easy print for Bambu printers. Small enough to fit on a keychain.
Printed in dual color Silk PLA, which is recommended. It tends to be “sticky” with MATTE PLA, from my tests anyway.
Make sure your build plate is clean to insure proper adhesion or add brim to the outside of the voronoi ball ONLY.
Comment & Rating (38)
All
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
I love this model. fun and beautiful
The designer has replied
1
Reply
looking good in gold, thanks for sharing your make!
0
Reply
Print Profile
1 ball fidget 0.2mm layer, 2 walls, 15% infill
Awesome Print, tweak little bit for eSun Magic Triple Color(Gold-Green-Black)
(Edited)
0
Reply
Print Profile
1 ball fidget 0.2mm layer, 2 walls, 15% infill
Muy chulo.
Gracias por el aporte.
(Edited)
0
Reply
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
Printed well, slides really smooth
The designer has replied
1
Reply
thank you!
0
Reply
Print Profile
1 ball fidget 0.2mm layer, 2 walls, 15% infill
No issues printing! no brim. Thanks!
1
Reply
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
Cute design!
1
Reply
Print Profile
1 ball fidget 0.2mm layer, 2 walls, 15% infill
It kept breaking loose before it finished.
The designer has replied
0
Reply
this sounds like an adhesion issue. if it’s not sticking, you need to clean your plate thoroughly.
0
Reply
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
I made a metric ton of these and gave them out at work. They were a huge hit!
1
Reply
Print Profile
for A1 single fidget 0.2mm layer, 2 walls, 15% infill
it failed both times I tried to print. I feel it was most likely my fault as being new to printing did not know about glue lol. it printed to the bottom of the finial then fell over so still had fun using it as a fight toy
The designer has replied
0
Reply
you gotta make sure your build plate is clean and at the right temp. it’s a bit challenging for a bed slinger, so slowing it down might help.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld