No Print Profile yet. Add one to earn points.
I created a set of Super Mario characters in watercolor for my son's room.
One of these characters is Luma . It is created in Hueforge.
If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.
See my other paintings
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA PolyTerra Army Blue Transmission Distance: 0.3
PLA BambuLab Matte Lilac Purple Transmission Distance: 2
PLA BambuLab Matte Sakura Pink Transmission Distance: 3
PLA META Sunlu Grey Transmission Distance: 5
PLA BambuLab Matte Ivory White Transmission Distance: 4
Swap Instructions:
Start with Charcoal
At layer #5 (0.48mm) swap to Army Blue
At layer #6 (0.56mm) swap to Lilac Purple
At layer #10 (0.88mm) swap to Sakura Pink
At layer #16 (1.36mm) swap to Grey
At layer #17 (1.44mm) swap to Ivory White for the rest.
The model is not as tall as your last slider. Consider checking the Full Range button or change your Depth Mode.