Darth Vader Statue with LED Light Up Base
Remixed by
Darth Vader Statue with LED Light Up Base
Remixed by
Boost
63
102
19
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
Designer
11.6 h
3 plates
Boost
63
102
19
0
167
108
Released
Description
Heres a Darth Vader lamp I came up with and uses LED strip.
For the Vader Statue, do a filament swap at 1.4mm using 0.2mm layer height.
For the base it will need the AMS, if there is enough interest I will make a version that won't need it.
Assembly is basic, stick the LEDs to the base and run the cable out of the hole. I use SK6812 LEDs and a USB LED Driver with a remote for control. You could also use an ESP32/ESP8266 and run WLED. Glue the Saber Blader into the saber hilt with some CA/Super Glue.You may need to resize the saber to get a good fit.
If you don't want to white slots in the base to glow, just run a strip of something like aluminium foil to block the light, I suppose you could also paint the inside black.
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
Love this print.
The designer has replied
1
Reply
Thanks for posting your make, it looks amazing! you did an awesome job!
0
Reply
fantastic！
The designer has replied
1
Reply
thanks for posting, it looks awesome!!!
0
Reply
is it possible to print the vader without supports?
The designer has replied
0
Reply
No, it really needs supports, you could cut the model into pieces but its easier to just use supports.
0
Reply
Replying to @pumpkin20303
hmmm, i printed it once with the supports but its so hard getting them off without ripping off his fingers or scratching the back of his helmet.
0
Reply
Replying to @user_1791757260
I've printed about 15 of them and never had an issue, I also print in Matte filament which makes it easier to remove supports. I didn't design Vader, I remixed it into the lamp. What tools are you using to remove the supports?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
Great print
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
The base wa good but the profile for the Vader was no supports. As I startet it from bambu handy it didn't generate them
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Snug Normal Supports
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld