Yesturday I helped a good friend to improve his Camper.

Therefore I printed some Velcro holders to mount the Solar Panel & its Cable securely to a wall. The holders are for different widths of velcro and very strong. (I hang myself onto them as a test :D)

There are 3 different sizes.

• Small: For Velcro Bands up to 14 mm width.
• Medium: For Velcro Bands up to 22 mm width.
• Large: For Velcro Bands up to 30 mm width.

To mount the holder I recommend using 3,5 mm wooden screws. Always make sure not to not to overdo it when tightening the screws.

In the Car I used ASA Filament, 0,3mm layer Height, 0,6 mm Nozzle, 3 Perimeter & 25% infill.

Annother feature of this design is that the excess cable can be put in between the holder and the wall. So it will not open accidentally and look a lot cleaner. You also may take a very long strap and cycle it around several times this way.

Also the design is not only designed for cable management but can also withstand heavier tasks like storing tools.

Have fun and keep printin!

BTW: I designed other holders too for the electricity that I will release soon.