RJ45 Cap coupler Protection Cover for LAN cables
Copyright Claim
RJ45 Cap coupler Protection Cover for LAN cables
Boost
16
27
7
Print Profile(2)
no brim, 0.2mm layer, 2 walls, 15% infill
Designer
7.9 h
6 plates
with brim, 0.2mm layer, 2 walls, 15% infill
Designer
8.1 h
6 plates
Boost
16
27
7
2
46
51
Released
Description
Some variations of a RJ45 cap (8P8C)
You can select the variants over the print profiles.
There is one profile without brim and one with brim, if you have difficulties with bed adhesion.
- caps labeled 1 to 48, ideal when swapping a complete switch or patch panel
- blank cap without label as protection cover
- cap with eyelet
- cap with band (best to print in TPU)
- RJ45-coupler (only for pulling, not for networking)
Also see my other network equipment:
Comment & Rating (7)
All
Boosted
Hi, this is an awesome tool! Is it possible to create a forty-eight ports version? otherwise, i will print two sets with two distinct colors. thank you!!!
The designer has replied
0
Reply
Hey, I uploaded a 48 ports version for the dummy switch panel, to you also need single caps labeled 1 to 48?
0
Reply
Boosted
Replying to @chrisax212
Yes, that's it. If it's not too much work
0
Reply
Replying to @PitiChuc
Done, just use one of my print profiles, on build plate two you will find a 1 to 48 version.
0
Reply
great collection of various caps. printed perfectly.
1
Reply
Print Profile
no brim, 0.2mm layer, 2 walls, 15% infill
very useful little gadget.
printed with default settings and it works fine!
0
Reply
Print Profile
no brim, 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld