Roku Remote Holder
Roku Remote Holder
Boost
5
11
14
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
0.2mm layer, 2 walls, 15% infill
23 min
1 plate
0.2mm layer, 2 walls, 15% infill
31 min
1 plate
Boost
5
11
14
0
42
70
Released
Description
Minimalistic Roku remote stand with a cut out in the bottom for the Roku tag on the remote. Just 3M tape it on your wall [remote is light enough no to need a screw] to hold your Roku 4/Ultimate, TCL P607 (ticker) remotes. The idea was using minimal amount of material.
If you'd rather secure it to the wall with a screw, you can find version with screw mount hole added here
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Works well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this is good for what I need. I’m not a big fan of using sticky tape and wish there was a cross bar in back with a hole to use a screw mount. but good enough for a remote for me.
0
Reply
Check Remix, i'm adding a version with a screw hole just for you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
if you have a Roku remote I recommend this for you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld