Lift Table 130x100
Copyright Claim
Lift Table 130x100
Boost
104
218
15
Print Profile(1)
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
8.1 h
4 plates
Boost
104
218
15
1
266
220
Released
Description
Summary
There are no details here except those that you can print yourself.
Supports should only be set when printing Base_gr and Base_top, the overhang angle of the support is 82 degrees, so that the support is not printed in the holes, otherwise they will be difficult to clean.
All the details are located in the files with the orientation as they should be printed. The required number of parts is multiplied for successful assembly.
The platform dimensions can be easily modified, increasing to 250 mm if necessary for your needs. During the test, the platform withstood 5 kg of cargo.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
20
Comment & Rating (15)
All
Very cool - fits together really well (printed on x1c).
Only thing is two of the bolts - the 7mm ones that join Rods 2 & 3, seem to be the too short - the same in the video - I printed off a couple more of the longer 14mm ones instead of the two short ones - and then it all fitted perfectly. Thanks!
0
Reply
Great model. Thanks. Had to use cellotape to keep the screws in but not a hassle
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
Super Teil! funktioniert wunderbar. Dankeschön!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
handy little thing!!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
no assembly instructions
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
fun
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
Printed perfectly. I'm using it for looking at electronics under a microscope.
0
Reply
can this be scaled down to 100x70?
0
Reply
Naja…. vielleicht nochmal überarbeiten
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld