D&D Session Box v1
Copyright Claim
D&D Session Box v1
Boost
35
85
10
Print Profile(3)
0.2mm layer, 3 walls, 15% gyroid infill
Designer
4.1 h
1 plate
2 Colors - Separate Colors & Plates for top/bottom
Designer
3.6 h
2 plates
0.2mm layer, 3 walls, 15% infill
50 min
1 plate
Boost
35
85
10
1
89
71
Released
Description
General Info
First iteration of my D&D Session Box idea. I took some inspiration for including the pencil/pen slot from other designs and incorporated it into my original design (which I never released) so this box is a little bigger.
Features
- Holds a set of 7 dice typical for D&D session (D4, D6, D8, D10, D%, D12, D20)
- 1-2 spots for miniatures
- A slot for other accessories (inspiration tokens, larger D20s, etc.)
- A pen/pencil slot for taking notes
Uses eight (8) 6x3mm magnets to secure the lid.
Printing
Pretty straightforward model. Not a lot going on, but some tips below:
- Printed in PLA
- .2mm layer height
- 15% infill
- Recommend 3 walls instead of 2 for increased durability
- Recommend using a brim for the box if you have warping issues
Supports
- Box: no supports needed
- Lid: recommend supports under the magnet slots and the small “handle”
Feedback
Looking for feedback to improve/enhance the design. Please let me know what you think, if you would improve anything, etc..
Thanks, and happy printing!
Comment & Rating (10)
All
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
cool , had some warping but turned out great, Will do another print with some brim , thanks for sharing!
The designer has replied
1
Reply
Oh no—there SHOULD be a brim on that profile! I checked and it's set to auto. Oops.
Thank you for letting me know!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
easy print. I made mine in Bambu Silver and it looks great. was a gift and forgot to take a picture
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
perfect for a gift to first time players
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
magnet holes on the lid were a bit difficult to remove. but it turned out great otherwise!
0
Reply
The print profile is no longer public
printed four of these with no issues, everything fit and looks great. Model tip though, make sure you put the magnets in correctly 😜
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% gyroid infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld