Filament Clamp with Label
Copyright Claim
Filament Clamp with Label
Boost
41
83
29
Print Profile(2)
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
Designer
1.4 h
2 plates
0.16mm layer, 2 walls, 15% infill
1.4 h
2 plates
Boost
41
83
29
0
235
239
Released
Description
I have also designed a version of my filament clamp where you can insert a small label with the material on it.
I designed it in two parts which are then plugged together.
The parts can be printed without support and only 1 filament change is necessary for the plates
The parts are best printed in PETG
Comment & Rating (29)
All
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
good design that works for a wide variety of brand of spools
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
nice design, thanks
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Strength Issue:some didn't print correctly and some broke and won't hold the name plate
0
Reply
Hello, it may be due to the filament used or the print quality. The best results are achieved with PETG as it is slightly stronger than PLA. It is also important to print with a good resolution, as the parts are very small. 0.16 high quality has proven to be good
0
Reply
Replying to @Staprin3D
I have also uploaded a modified print profile for PETG with more infill so you can try it again.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
For my filament bbox..
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
very useful and sized well
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
Molto itili
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
0
Reply
Print Profile
Clamp: 0.16mm layer, 3 walls, 50% infill gyroid
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld