Summary

Model V1 has a wider bottle neck than V2.
I think V2 fits a little better at the neck of the bottle, but you can also adjust the neck to a bottle later by heating it with a hairdryer if you want to.

You need a slicer for the model that generates a tree support. I used Bambu Studio.
Here I had to construct something on the ground so that the part of the bottle stays in the air.

I have created V3 but I tried to pull the model from the support.
Next time I will keep it in place.

Today I created V4. It's a bit smaller, but it fits better on the neck of the bottle.

I had also sometimes a slightly different tree support again by simply repositioning the model or the angle of the model to the build plate.

I love this model. I hope you do too ;)

Here is my Instagram post for this model:
https://www.instagram.com/p/Cs4A_7sNH57/?igshid=MzRlODBiNWFlZA==

Print Settings

Printer:

Bambulab X1C

Rafts: 

No

Supports:

Yes

Resolution: 

0,200

Infill:

15%

Filament: Bambulab PLA Metal Green