Wind chimes:
Here is a small wind chime in two versions with cats or owls.
The parts are easy to print without support.

Three additional ball bearings measuring 8x16x5mm are required. These are simply pressed into the seats.
Available here, for example: https://amzn.eu/d/fWI8sm3

Important: When assembling the figures, make sure that the narrow stop of the cats points towards the tail and the owls towards the outstretched wing.
If the figures are loose, use a little glue.

Depending on the print quality, the locating pins in the bearings may be a little tight, in which case simply sand the pins a little with sandpaper
Have fun