I liked this original design by Humbeam, but it wouldn't stay on my AMS and the back kept lifting up and disconnecting. Also the top of the button was hitting my AMS cover and putting pressure on the buttons causing filament change issues if it was pushed closed.

I modified this in the bambu slicer so it isn't perfect, but it all worked out and is functional. it can still be printed without supports even though the slicer will ask you to enable supports.

Also you can still paint the Bambu logo on the button face, Color it in the slicer. The logo is a little off from changing the angle, but you really can't tell.

Revisions.

1. Took the original (for the new AMS, thick button) with the larger hole (4.2mm) that fit my tubing.
2. Sliced if off so it doesn't have the top rise on the front of the button that was hitting my cover.
3. adjusted the backing lip to 3.22mm (that is what my button measured thick) so it was as tall as the back of the button
4. Added a lip that would catch over the back of the original button so it would latch in place and not keep getting pulled off.