David on podest By Michelangelo
Remixed by
Boost
38
70
11
Print Profile(1)
0.15mm layer, 2 walls, 5% infill
Designer
3.9 h
1 plate
Boost
38
70
11
0
141
59
Released
Description
changed the size, added a podest and changed the print settings - 19cm - 2,5 hours on 166%speed!
Comment & Rating (11)
All
Print Profile
0.15mm layer, 2 walls, 5% infill
Well this was my sixth print since I received my printer today and this was perfect skill level for me lol. I loved the detail of it. I learned a lot about the supports off of it also. I had a problem with the rod fitting into the base…..long story short, I glued the bust on to the pedestal. I wasn’t aware of PLA “strength” lol.
(Edited)
The designer has replied
1
Reply
nice looks good, i think this also was one of my first prints :D ! thanks for the feedback
(Edited)0
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
Looks awesome, didn't print the base tho
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
Nice model! I love that it prints fast and quite clean. The only issue as other have reported is the dowel doesnt fit in the bottom. Im guessing that the weight is deforming the opening underneath.
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
Looks fantastic scaled up some done in marble filament
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
1
Reply
Print Profile
0.15mm layer, 2 walls, 5% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld