Honeycomb Napkin Holder
Copyright Claim
Honeycomb Napkin Holder
Boost
2
13
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
5 h
1 plate
Boost
2
13
5
0
29
24
Released
Description
A simple napkin holder, designed to be printed in place with no supports.
I suggest printing with PETG for moderate flexibility, though as you can see from the picture, that will make it a bit more "boogery"
Can be scaled up to fit your napkins better. The default is for IKEA's 30x30cm napkins, though I wish I'd actually made it a bit bigger. I'd probably print at 125% scale if I were you.
NO SUPPORTS!
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
N/A, 3 perimeters makes it 100%
Filament: eSUN PETG Black
BTW, If you want more things you didn't know you could print, here's a list of 50+ similar items:
Category: Household
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:some of the Combes didn’t print correct and was fragile. can’t hold a lot of napkins.
The designer has replied
0
Reply
That's weird, I have mine holding around 50 napkins without a problem, care to show photos of your print?
0
Reply
I believe you might not had good adhesion in your bed, because this design even if not mine is very well done.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Leider 3 kleine Verbindungsfehlet in den Waben. Etwas drüber geklebt und sieht man nicht mehr. Rest klappte super. Vielen Dank.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld