f-22 raptor (detailed)
Copyright Claim
f-22 raptor (detailed)
Boost
49
74
17
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Draft 0.24mm (not so fine quality)
Designer
1.9 h
1 plate
Boost
49
74
17
1
300
159
Released
Description
Summary
this is a fine model of an F22 Raptor not much more to say. the rudders can be pretty hard to print so maybe try scaling it up. hope u enjoy it
(I have updated the print profile as many had problems. There are now connectors added to the model, you may need to sand/debure the connectors a bit. another tip is to cut off the tip of them so they fit easier :). )
Any feedback is appreciated.
Comment & Rating (17)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Perfect print on the A1 mini!
(Edited)
0
Reply
Print Profile
Draft 0.24mm (not so fine quality)
le parti non si uniscono troppo bene
0
Reply
The print profile is no longer public
horrendous
The designer has replied
0
Reply
try the new print profile :)
0
Reply
Replying to @Toxvaerd
ok
0
Reply
The print profile is no longer public
had issues with the design. the wings and tail fin are to thin. also supports need to be turned on or it will make spaghetti.
The designer has replied
0
Reply
try the new print profile :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
when i went to connect the pieces they didn't fit flush
0
Reply
The print profile is no longer public
The designer has replied
0
Reply
try the new print profile :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Strength Issue:the Wings are very unstable but the Rest is good
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld