Drill Holder for 1" Spaced Soft Pegboards

• Design Specifics: Created for 1" hole offset in soft pegboards. Provides a secure fit specifically for this setup.
• Compatibility: Tested with Ryobi drills. The holder matches well with these models.
• Material Suitability: Ideal for soft pegboard materials. The fit is very tight and may not be suitable for stiffer pegboards without some adjustments.
• Usage Note: Designed for a snug fit; consider slight modifications if using with harder pegboard materials.

This holder is straightforward in its function and design, intended for those who need a reliable tool storage solution.

I printed with PLA-CF but it should be strong enough with any material.

Print Settings:

• 0.2mm standard X1C
• 15% Gyroid infill
• 6 Wall loops to provide the strength.
• Auto supports enabled (Should only be needed for the pegs)

I didn't really optimize these settings as it was a one off I figured I'd share with the community.