Inspired by the Voron 2.4 enclosure I made my own for the Prusa i3 MK3S+.

Exterior Dimensions are 614 x 556 x 518mm.

The Case is sealed from all sides but air can still flow in from below to vent the electronics. The whole enclosure sits on rubber feet (from High-End Audio Speaker). Additionally a Raspberry Pi 4 enclosure can be mounted inside and the HQ Camera attached to the aluminum extrusion.

Printed Parts required:

• 16x Corner Piece
• 4x Hinges
• 2x Left Latch
• 2x Right Latch
• 2x Latch Base
• 6x LED Strip Angles
• 4x Rubber Feet Mounts

Sourced Parts required:

• 8x Aluminium Extrusion 2020 - 500mm
• 4x Aluminium Extrusion 2020 - 560mm
• 44x Flat Head Screws M5x8
• 8x Nuts M5
• 8x Washer M5
• 36x T-Slot Nuts M5
• 6x Hex Screws M3x6
• 6x T-Slot Nuts M3
• 4x Round Magnets 7-8x1mm
• 2x Acryl Panel - 573 x 473 x 3mm
• 1x Acryl Panel - 573 x 513 x 3mm
• 1x Acryl Panel - 513 x 473 x 3mm
• 2x Acryl Panel - 472 x 255.5 x 3mm

Compatible with following extensions:

• Filament Dry Box IKEA Samla 22L (https://www.printables.com/model/116955-filament-dry-box-ikea-samla-22l)
• Raspberry Pi HQ Camera Case for T/V-Slot (2020) (https://www.printables.com/model/82579-raspberry-pi-hq-camera-case-for-tv-slot-2020)

_______

If you like my uploads buy me a coffee -> https://bit.ly/pwave-donate