No Print Profile yet. Add one to earn points.
I finally got around to identifying and removing some of the annoying vibration noises on my Prusa.
I've designed 3 little widgets.
• The little U-shaped widget goes where the screen clips onto the LCD board.
• The round widgets go through the 2 M4 bolt holes on the power supply to push that vibrating insulation sheet away from the case.
• The other wedge shaped widgets I haven't tested, but they should slot through the vents of the power supply to help hold the insulation sheet if needed.
Print them in TPU or some other flexy, squishy filament.
Print in TPU or some other flexy filament.
No supports required.