TIG/WIG Grinding Tool for Multitools

What you need: Dremel / Parkside Multitool, 35mm Diamond Grinding Disk (f.eg. ebay)

Each Head has 3 positions that can be used, each Position uses a different radius on the grinding disk

Diameter available: 1.6mm and 2.4mm

Angles available: 30 deg, 45 deg and 60 deg als well as a combi head

Health and Safty Warning
You do it on your own risk

How to set up

Step1
Insert the shaft of the grinding wheel into the collet chuck and tighten it slightly (so that it still move a bit and sticks out of the lower part). Screw the lower part of the tool onto the dremel.

Step2
Put the grinding wheel onto the shaft (without the screw) and use the top part of the tool to press the grinding wheel and the shaft into the correct position. (When it fits to the lower part)

Step3
Remove the lower part of the tool from dremel and tighten up the collet chuck.

Step 4
Screw the lower part on dremel again, fit the grinding wheel with the shaft and screw the needed top part on.

Use a 2.5mm, 1.7mm Drill to open up the holes if needed (or use a hot TIG elektrode)

Ready to grind

Other diameters and angles possible if needed.

Same file als my design

https://www.thingiverse.com/thing:3723973

More download availible

Youtube