4 glasses holder / stand
Remixed by
4 glasses holder / stand
Remixed by
Boost
41
69
15
Print Profile(2)
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
Designer
5.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
5 h
1 plate
Boost
41
69
15
1
132
97
Released
Description
Although I prefere original 3 glasses stand, somebody may require 4 glasses display. Here it goes… my vision of angeled glasses display where you can easily pick the one you want and do not destroy the above places ones…
PET-G this time, tree supports are necessary (my choice was 20% angle and strong again…
Hope you will enjoy the design.
Comment & Rating (15)
All
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
love it!
The designer has replied
1
Reply
I'm hlad you like it. Thank you for your stars 👌😉
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Der erste Druck musste abgebrochen werden. Dann Stützen neu angeordnet und Druckgeschwindigkeit reduziert, lief es perfekt.
The designer has replied
0
Reply
I made a modification for it... it seems that the flaps were too narrow (2.3mm). They broke even at my friend's print, he reported. And as the flaps rests on supports this may be critical part that the contact point was not sufficient. After a test of 3mm flaps, all went well - two prints.
There are two options - slow down and cool as you suggested (and easily you can use for that purpose Silk preset) or use second profile (wider flaps). I hope this helps and hope you will try some of my other designs ;-)
Happy printing, Schrammi.
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
The designer has replied
1
Reply
thank you for your ratings. 🙏
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
had to add additional supports
(Edited)0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
Support Issue:bei der Langen schräge wären Supports besser
The designer has replied
0
Reply
It Is strange. My print goes on PEI, surely with 3dLac sprayed laser. for adhesion. I switch between PETG And PLA... Maybe you can increase walls thicknes to 3... or rise thé infills from 15% to 20%.
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill wider flaps
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld