Large “Costco Size” Battery Trays
Copyright Claim
Large “Costco Size” Battery Trays
Boost
48
116
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.4 h
1 plate
Boost
48
116
16
0
165
91
Released
Description
This is the Duracell version of The Costco Friendly Battery Tray. It holds 40 AA batteries, 40 AAA batteries, and eight 9-volt batteries. These are the amounts you will get if you purchase a pack of Duracell batteries from Costco in each of the three types. It will of course fit any brand of batteries you have.
There is also a Kirkland version of The Costco Friendly Battery Tray available which holds 48 AA and AAA batteries at https://makerworld.com/en/models/129086
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Needs to be updated to the 48 pack of AAA batteries... 😁 Makerworld doesn't think I printed even though I have a picture of the print and it was run on a X1C or this would have been a 5 star.
The designer has replied
1
Reply
I've been thinking about that since Kirkland batteries come in 48 for the AA and AAA sizes. They are actually a better deal than the Duracell ones.
0
Reply
Ok, I've added two 48X48 trays and one for 48 AA's and one for 48 AAA's. There is a link in this models description.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Mit PLA gedruckt. Einwandfrei :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love it
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Dankbarer erster Druck!Sehr stabil und hochwertig!Danke
The designer has replied
1
Reply
Graag gedaan.
0
Reply
Great idea, but would it be possible to remix it with 50 each of AA/AAA and no 9v?
The designer has replied
0
Reply
If you'd like to do a remix you are more than welcome.
0
Reply
I've added some 48X48 AA/AAA trays. Not quite 50 but close! There is a link in this models description or just check out my published models.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print. I added a full brim to prevent edge lift.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld