Bracket SeeMeCNC Y-Filament Splitter M3x4 and 10 mm Magnet
Remixed by
Copyright Claim
Bracket SeeMeCNC Y-Filament Splitter M3x4 and 10 mm Magnet
Remixed by
Boost
0
1
5
Print Profile(2)
Wider - 0.2mm layer, 4 walls, 15% infill
Designer
33 min
1 plate
0.2mm layer, 6 walls, 25% infill
Designer
31 min
1 plate
Boost
0
1
5
0
3
3
Released
Description
This is for SeeMeCNC Y Splitter credit goes to Roland Deschain for the original design I remixed from scratch for the following reasons
- Didn't want to buy any extra parts
- Uses 10x3 magnet which I had on hand (press fit it's snug)
- Uses M3x4 nut
- Uses M3X20 round head screw
- Also increased the distance by 5mm from the printer for me the original caused too tight a radius
Comment & Rating (5)
All
Print Profile
Wider - 0.2mm layer, 4 walls, 15% infill
thank you very much appreciated
0
Reply
great design. i printed it out of petg and it doesn't quit close flush together. the original has it a little bit wider where the splitter is that's where it hangs up a bit. maybe check it out. i tried filing it a little bit but gave up.
The designer has replied
0
Reply
I will look into it and make some adjustments and upload a new version tomorrow afternoon
1
Reply
I just uploaded a wider version where I increased the cutout for the splitter, hopefully this one works better for you.
1
Reply
Replying to @ondrovic
thanks dude I'll give this a print and report back!
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld