As Han Solo says: “Hokey religions and ancient weapons are no match for a good blaster at your side, kid”.
This is a great blaster model. It's easy to put together, prints well and the supports on it can be removed without much effort. The barrel prints at an angle not because I'd had a couple of beers before doing the model, but because, at that angle it prints some of the thin vertical parts of the barrel well and without too many supports.
I've put in a couple of model tweaks here to make this print a little better and it prints really well on a P1S.
A word of warning: I tend to use Creality filament because it's cheap, it's reliable and it paints well, so you may want to have a quick look at the filament/flow rate settings for the filament because Creality filament prints well at a slightly lower flow rate than the P1S default.