This is the Third part of the inspired model of a War-Rig. This part includes the Fuel Pod of the Rig.

CLICK HERE TO FIND PART 1 OF WAR RIG

CLICK HERE TO FIND PART 2 OF WAR RIG

WAR-RIG ASSEMBLED IN FULL

Three ways to print

1. As single piece:- Please download STL file but there wont be any movements.
2. Multiple Pieces :- Download 3mf file with Full_dismantled.3mf.BEST QUALITY OUTPUT. Please use the 3mf file for assembly also.
3. Combined:- You may use any 3D viewer software like 3D builder in windows to merge components according to your printer and filaments. The sky is the limit for this. A sample file might be already provided for download. Please check for file ending with comined.3mf

ASSEMBLY OF FUEL POD & MATING WITH TRAILER

Follow the GIF for mating of fuel pod with trailer.

NOTE The tolerances to some elements are zero which has been intensionally provided to friction lock the elements while not in movements. You may have to fine tune the tolerance from your end using scaling funtion in slicer to ensure good fit without compromising movements.This also applies for the pins that make rotation possible between elements. Please proceed with printing all the pins after testing printing a pin and testing the fit of a joint. You should be able to find the adequate scaling factor with this.

The main body is made hollow to ensure filament savings.

Supports should be provided as required.

Appreciate the makes uploads.Open for suggestions.