This is a simple clip on storage bin for the Lekato PA-1 Pocket Guitar Amp, which is a mini amp with a battery to which you can connect headphones for quiet / travel practice. The storage compartment's main compartment holds the PA-1 and there is a smaller side compartment to hold picks. I have a single upright floor guitar stand that holds my guitar and this lets me keep the PA-1 stored in a safe and easy to find location.

Notes for Adaptation:

• The diameter of the tube on my stand is about 19.4mm and I made the inner throat of this clamp 19.0mm and it has a tight enough grip that it does not slip. If adapting you may need to play around with throat depth, angle, etc.
• STL is uploaded, but this was originally made in tinkercad using built in components if you want to start from scratch to do something similar, very quick and easy even for a beginner: Search for “clamp” and there is a similar type of clamp from the community objects that is parameterized to easily adjust as needed. The two compartments should be reusable if you upload the STL I am providing on this page, just create a new clamp to meet your needs. May take an iteration or two
• I made the clamp start at the bottom rather than just in the middle to avoid support, which used more filament than just making the clamp taller
• When customizing note there is a bump out on the backside of the PA-1, take this into account or store the lekato with the buttons facing in towards the tubing.