R36S Retro Handheld Hard Case
Copyright Claim
R36S Retro Handheld Hard Case
Boost
8
21
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
1 plate
Boost
8
21
4
1
46
25
Released
Description
A hard case for the R36S retro gaming device. The case was designed to allow the buttons, joysticks and screen ample room inside the case. There is room to glue in a thin piece of felt above the screen for added protection.
There are two variants, one using 8x3mm magnets and another that uses a simple latching mechanism. The hinge fits a small length of filament.
The cases seen in the photographs were printed in Bambu ABS without supports with a 5mm brim at 0.20mm
Comment & Rating (4)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
I printed this masterpiece of a project with a lot of fun and I discovered that if placed in a certain position it remains in the gaming station... if you want, look at my profile with a "like" thanks friend!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed tidy nice little case. thanks
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld