Universal Spool Weight for 500g weight by Guilouz

Guilouz

3D Printer>3D Printer Accessories

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 10% infill

Designer

2.1 h

1 plate

4.8(56)

0.15mm layer, 4 walls, 15% infill

2.3 h

1 plate

5.0(6)

Basic PLA Print - 0.25mm layer, 2 walls, 12% infill

1.8 h

1 plate

4.0(7)

Boost

122

470

456

Released

Description

This adds weight to your spools so they stay in place when there is little filament left.

Tested with many brands of filament spools like Prusa, Raise3d, Sunlu, Eryone, BambuLab, Wanhao, Flsun, Geeetech…

Some spools like Geeetech need “Extender.stl” part to be used because the inner diameter is larger than normal.

It was modeled to be used with a weight of 500g available here:

Comment & Rating (75)

@Jamboodle

Boosted

Print Profile

Basic PLA Print - 0.25mm layer, 2 walls, 12% infill

Prints great, works great. This spool weight has fixed the majority of my AMS problems. Fits every spool I have tried it with. The cheapest thing I found to fill it with was pennies.

@agustafson1

I did the same thing with pennies :)

@McFly.FPV

Print Profile

Basic PLA Print - 0.25mm layer, 2 walls, 12% infill

👍🏼 I like it

@geeklabs

Print Profile

0.2mm layer, 2 walls, 10% infill

Printed with ABS+, 0.2 layers, 0.4 nozzle, stock X1C, stock settings. Perfect!

@konx2k

Print Profile

0.2mm layer, 2 walls, 10% infill

Nice model... thx :)

@warlogh

Print Profile

0.2mm layer, 2 walls, 10% infill

Good design. fits 500g weight very well. just needed to put a bit of paper tissue to complete security a weight ant completely prevent wobbling. only sad about it is a license type. I made an adapter for my very wide SUNLU spools and wanted to share it as Remix, but found that licencing doesn't allow to do anything.

@madb1x

Print Profile

0.2mm layer, 2 walls, 10% infill

works great, thank you :)

@Square3D

Print Profile

0.2mm layer, 2 walls, 10% infill

Fits perfect. Thank you

@Melbo0

These are so nice. Solved my AMS problems with light spools and also some filament dryers I have mounted at an angle on printers. Since I mostly use Bambulab spools or clones of BL spools, I created a small conical spacer accessory that takes up any slack in fitment and perfectly centers the weight. Thanks for the design and for sharing.

(Edited)