Christmas tree topper - vase mode
Boost
9
9
14
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
1.1 h
1 plate
Boost
9
9
14
0
53
57
Released
Description
Christmas tree topper
make sure vase mode is on
Comment & Rating (14)
All
Print Profile
0.2mm layer, 1 walls, 0% infill
perfect
(Edited)
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
very nice!
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
You should make the bottom hollow so it fits on a tree.
The designer has replied
0
Reply
the file should be hollow.
but you can remove it easy with sharp knife. worked fine here
but i will check later for an update
(Edited)0
Reply
I just updated the file, with bottom layers set to 0, should do the trick
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Super einfach, schnell und bezaubernd
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
perfetto
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld