Bambu-Lab-P1S-scrap-box
Copyright Claim
Bambu-Lab-P1S-scrap-box
Boost
1
1
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.9 h
1 plate
Boost
1
1
5
0
4
2
Released
Description
A box to put the string the Bambu prints at the start on the build plate. I made a Bambu labs box with the perfect dimensions to store the scrap test print for the P1S.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
it printed of fine quality and sturdy. the issue is it should have some kind of catching system as most of the scrap misses the box completely. leaving my work desk full of plastic. outside of that (a major point) it's nice
(Edited)The designer has replied
0
Reply
haha what do you mean? i just use it on the side of my printer and pick off that test line with my fingers and put it in the box. how were you using it?
0
Reply
oh I can take pictures later (if I remember to) after work
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
just throwing 3 stars out or was something wrong with it?
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld