A remix of Capt Obvious' SKR mini enclosure (https://www.thingiverse.com/thing:4012555).

Fits the SKR 1.4 board. Designed mostly for Core XY machines, where the control box sits up high near the extruder cabling.

Includes multiple cable ports on three sides.
5 ziptie cable holders in the top cable port (near the stepper motor ports).
Very well ventilated.

Simple print. Just use some support from the build surface for the nut/bolt pockets. Needs 4 m3 square nuts (thin).

Things to do. M4 bolt holes are a little big. Still works fine but washers aren't a bad idea.

Update: Added a 'fan backpack'. This is a small adaptor that bolts to a 40mm fan (use m3 heatset inserts), and then clips onto the hex-pattern of the lid or case.

Update Jun 2021: Added a mosfet enclosure for the MKS-bed Mosfet - https://www.biqu.equipment/products/3d-printer-parts-heating-controller-mks-mosfet-for-heat-bed-extruder-mos-module-exceed-30a-support-big-current