Digital Caliper Battery Cover (latching)
Copyright Claim
Digital Caliper Battery Cover (latching)
Boost
6
3
6
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
13 min
1 plate
Boost
6
3
6
0
29
28
Released
Description
A latching battery cover for Chinese digital calipers (they come from many brands, e.g., UPM Model 111-021).
When printing, experiment with supports.
I printed mine with Bambu Lab PLA Basic and supports that I carefully cut and sanded away. The fit gets better with a couple of uses.
Comment & Rating (6)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
the inside of the door dint fit mine but .still a good print
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Works well enough, still had to use electrical tape to hold it on to avoid losing the door and battery again, but it's better than not having it and having the battery disconnect all the time.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld