Earphone holder under table
Copyright Claim
Earphone holder under table
Boost
7
5
5
Print Profile(1)
0.2mm layer, 2 walls, 35% infill
Designer
1.4 h
1 plate
Boost
7
5
5
0
23
14
Released
Description
ENG:
This headphone holder can be attached under the table without drilling. I attached it with "tesa Powerstrips". My large Beyerdynamics headset fits there. Width of the bracket max. 55mm. I printed the holder with PETG and 35% infill without support.
GER:
Diesen Kopfhörerhalter bringt man unter dem Tisch ohne Bohren an. Ich habe ihn mit "tesa Powerstrips" angebracht. Dort passt mein großes Beyerdynamics Headset drauf. Breite des Bügels max. 55mm. Habe den Halter mit PETG und 35% infill gedruckt ohne support.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 35% infill
Came out very strong. A bit stringy under the lip.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
In den Rundungen sehr viele Fäden mit PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld