Gridfinity Superlight Baseplates - Half Grid Edge
Remixed by
Copyright Claim
Gridfinity Superlight Baseplates - Half Grid Edge
Remixed by
Boost
76
185
32
Print Profile(3)
P1/X1 Series
Designer
9.9 h
19 plates
A1 Mini
Designer
2.4 h
6 plates
A1
Designer
12.2 h
20 plates
Boost
76
185
32
0
405
455
Released
Description
Remix to make use of the edge of the drawer with half width bins when there is space left over in the drawer but not enough to put in a whole cell.
Gridfinity baseplates completely remodelled from scratch, designed to minimise print time.
- Lower overall height (top trimmed)
- Flares on the bottom removed
- Smaller radii
Designed for PLA and other materials with good first layer adhesion.
Check out this collection for my other Gridfinity models and
check out this collection for my Honeycomb Storage Wall models.
Comment & Rating (32)
All
Print Profile
A1 Mini
Thin, quick to print and you can make use of that little extra space!
0
Reply
printed with petg, works, secured with screws a bit to avoid it being loose
0
Reply
Print Profile
P1/X1 Series
Quick print and bins fit perfectly!
0
Reply
Thank you for some nice minimalistic baseplates! Both these and the full-size variant.
It would be nice if you also added baseplates with half-grid on two edges for even more flexibility.
0
Reply
Print Profile
A1
Worked just fine. Worked in my case off odd-sized ikea drawer - to hold the grid base in a good position. Thanks Mr Designer.
0
Reply
Print Profile
P1/X1 Series
Great option when trying to fit drawers more completely. Prints quick and easy.
0
Reply
Print Profile
P1/X1 Series
nicely done.
0
Reply
Print Profile
P1/X1 Series
(Edited)
0
Reply
Print Profile
P1/X1 Series
0
Reply
Print Profile
P1/X1 Series
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld